SN 100 SLE

SN 100 SLE is a premium high-gloss, self-smoothing resin flooring system, typically applied at a nominal thickness of 2–3 mm to achieve a seamless, durable, and aesthetically refined floor finish.

SN 100 SLE is engineered for dry process environments subjected to regular foot traffic, trolleys, pallet trucks, and rubber-wheeled forklift operations.

• Laboratories
• Cleanroom facilities
• Warehousing / storage areas
• Pharmaceutical, electronics, aerospace, automotive, printing industries

• Attractive; enhances working environment
• Hygienic – easy to clean
• Non-tainting, non-dusting
• Hard wearing floor finish
• Abrasion resistant
• High chemical resistance grade available
• Wide range of colour
• Solvent free, low odour

SN 100 SLE is suitable for application over concrete, wood, tile or metal. Not recommended on asphalt or painted surface.

• Minimum compressive strength: 25 N/mm²
• Substrate must be sound, clean, and free from laitance, dust, and contamination
• Substrate dryness: maximum 75% relative humidity (BS 8204)
• Must be free from rising damp and groundwater pressure

Cove Base: To provide an integral seal at the joint between the floor and wall. Coving can be formed with i-FLOOR Coving Mortar in conjunction with i-FLOOR Primer.

SN 100 SLE is packaged in a 22 kg set, consisting of:

Each set of SN 100 SLE will cover approximately 1.00 m².

Proper surface preparation is essential for optimal adhesion. The substrate must be dry, structurally sound, and free from grease, fats, oils, laitance, and all other contaminants.

Preparation should be carried out by totally enclosed shot blasting or mechanical scarification to produce a clean, open-textured surface with a profile comparable to fine sandpaper.

Normal porous surfaces should be fully sealed and primed using two coats of Primer.

• Add Part B into Part A and mix with blender for 60 seconds.
• Add Part C and mix with blender for 120 seconds.
• Scrape out residue of previous mix from the sides of the drum and discard before mixing the next pack.

SN 100 SLE has a working time of approximately 20–30 minutes at 30°C. Working time varies with temperature.

• Material must be used immediately after mixing.
• Use a screed rake to distribute the mixed material onto the floor.
• Use a V-notched hand trowel and pull through the material at right angles to the floor.
• Use a spiked roller to release air and help aggregate settle, allowing liquids to come to surface.

• Store unopened in dry conditions at 25–35°C.
• Avoid excessive heat and do not freeze.
• Shelf life is 12 months in original, unopened container.

Clean mixing and application equipment immediately after use. Use toluene or xylene. Observe all fire and health precautions when handling or storing solvent.